YG1 20598 3/4″ Size, 1-1/2″ LOC, 3 Flute, Bright Solid Carbide Finishing End Mill High Quality

Applications

This 3/4″ solid carbide finishing end mill features a high 60° helix with three flutes and center cutting ability, designed for precision finishing in aluminum, brass, bronze, copper, plastics, and other low-to-moderate speed applications where a sharp, polished cutting edge is preferred. The bright finish coating supports these materials by reducing built-up edge and enhancing chip evacuation, while the high helix angle shears material cleanly and lifts chips efficiently to maintain surface quality. Its 1-1/2″ cut length and 4″ overall length offer reach without sacrificing rigidity, and the single-end design keeps tool geometry optimized for fine detail work. Operators can rely on this tool to deliver smooth finishes on non-ferrous metals and plastics, especially where tool sharpness and surface finish are critical.

Features

• Excellent shearing and chip ejection due to 60 degree Helix.
• 20 degree ~ 30 degree increase in chip load recommended over 30 degree helix tools.