YG1 07593-060R 1/2″ Size, 1″ LOC, 0.060″ Radius, 4 Flute, Solid Carbide Finishing End Mill Budget

Applications

This 1/2″ solid carbide finishing end mill features four flutes and a 30° helix angle that builds core strength for steady, controlled cuts in aluminum, brass, bronze, copper, plastics, and other materials suited to low-to-moderate speed machining with a bright finish. The 0.060″ corner radius helps resist tip chipping during interrupted cuts, extending tool life. Its center-cutting geometry enables plunge and ramp entry, while the single-end design offers a rigid cutting profile for precise finishing. The 1″ length of cut balances reach with stiffness, and the 3″ overall length fits a variety of setups. Use this tool when a sharp, polished cutting edge is preferred, especially in applications demanding tight surface finishes and minimal burrs on non-ferrous and softer materials.

Features

• Possible for high-speed cutting, suitable for high efficiency maching for hardened & high alloy steels, steel casting, chill casting, malleable cast iron, CrNi-steels, brass, copper, aluminum with a high percentage of silicon and abrasive plastics.