YG1 83901TC 1/4″ Size, 3/4″ LOC, 3 Flute, TiCN Solid Carbide Finishing End Mill Buy Online

Applications

Applications that demand a balance of rigidity and reach are well served by the YG1 83901TC 1/4″ Size, 3/4″ Length of Cut, 3 Flute, TiCN Solid Carbide Finishing End Mill. It features a 3-flute configuration, a 50° helix angle, and TiCN coating to facilitate smooth chip evacuation and reduced built-up edge, key for clean finishing on non-ferrous materials like 6061 and 6082 aluminum. The 3.0x length-to-diameter ratio maintains stiffness while offering sufficient reach for precision work.
Recommended for finishing wall and floor surfaces in non-ferrous alloys, this tools high helix angle and low-friction coating improve surface finish quality. It also allows plunge cutting and slotting, thanks to its single-end, center cutting design.
Avoid heat-resistant superalloys (HRSA ISO S) with this end mill due to coating unsuitability that leads to accelerated wear. Although compatible with steel and cast iron, it is better suited for finishing rather than heavy roughing in those materials.

Features

• Designed to machine stainless steel, inconel, titanium and other hard to machine materials.
• It’s 3 flute design gives high stability and allows good chip removal in plunging & slotting operations.
• The high rake angle and 50 degree medium helix allows an extremely wide range of application.
• YG:TYLON super TiAlN coating are recommended for maximum performance.