In Demand YG1 07598-045R 3/4″ Size, 1-1/2″ LOC, 0.045″ Radius, 4 Flute, Solid Carbide Finishing End Mill

Applications

This YG1 E5216 solid carbide finishing end mill features four flutes and a slow 30° helix angle that enhances core strength for steady, controlled cuts in aluminum, brass, bronze, copper, plastics, and similar materials. The bright finish coating suits general low-to-moderate speed machining where a sharp, polished cutting edge is preferred, minimizing built-up edge and ensuring smooth chip evacuation. Its 0.045° corner radius resists tip chipping during interrupted cuts, extending tool life in finishing applications. The center cutting geometry allows plunge and ramp entry, while the 3/4″ diameter with 1-1/2″ cutting length balances rigidity and reach for detailed work. Operators should select this tool when precise surface finishes in non-ferrous and softer materials are required, especially when controlled feeds and speeds are employed to maintain the polished cutting edge and reduce heat buildup.

Features

• Possible for high-speed cutting, suitable for high efficiency maching for hardened & high alloy steels, steel casting, chill casting, malleable cast iron, CrNi-steels, brass, copper, aluminum with a high percentage of silicon and abrasive plastics.