YG1 85588TE 7/16″ Size, 9/16″ LOC, 5 Flute, YG TiAlN Extreme Solid Carbide Finishing End Mill Limited Offer

Applications

For precision finishing where rigidity and control are paramount, the YG1 85588TE 7/16″ Diameter, 9/16″ Length of Cut Solid Carbide End Mill delivers excellent results. Its 5-flute configuration combined with a 45° helix angle and YG TiAlN Extreme coating promotes superior surface finishes and effective chip evacuation in steel and similar materials. The stub length to diameter ratio of approximately 1.29 enhances stiffness and reduces deflection during fine finishing cuts. The variable pitch geometry coupled with a high flute count makes this tool ideal for finishing low carbon steels like 1018 and A36 by reducing vibration and improving surface quality. Its TiAlN Extreme coating supports extended tool life through enhanced wear resistance and heat management. The absence of a corner radius maintains sharp cutting edges but necessitates careful use to avoid chipping on interrupted cuts. Because the TiAlN Extreme coating deteriorates rapidly on non-ferrous materials, this end mill is unsuitable for such applications. Its design and coating are tailored for finishing steels rather than softer metals requiring different coatings and geometries.

Features

• Designed to machining stainless steel, inconels and other alloys.
• The new design of stub length allows cutting at maximum speeds and feeds with minimum deflection.
• 5 Flute and 45 degree medium helix allow harmonic balance and smooth cutting.