YG1 83905TF 1/2″ Size, 1″ LOC, 3 Flute, YG TiAlN Futura Solid Carbide Finishing End Mill Seasonal Sale

Applications

Featuring a 1/2″ diameter and 1″ length of cut, the YG1 83905TF solid carbide finishing end mill combines a stub length ratio with a 50° helix angle for a rigid and precise cutting solution. Its three-flute design, coupled with the TiAlN Futura coating, reduces friction and heat buildup, enhancing machining in steel, stainless steel, cast iron, and heat-resistant superalloys.
This high helix angle and low-friction coating synergy minimizes built-up edge and promotes smooth surface finishes in tough materials. The single-end geometry ensures rigidity and stability during finishing passes. Although the absence of a corner radius reduces concerns about edge chipping, care is advised during interrupted cuts.
The tool is unsuitable for non-ferrous materials due to coating unsuitability, which can cause premature wear. Its characteristics align closely with finishing applications focused on ferrous metals, providing clean cuts and consistent surface quality.

Features

• Designed to machine stainless steel, inconel, titanium and other hard to machine materials.
• It’s 3 flute design gives high stability and allows good chip removal in plunging & slotting operations.
• The high rake angle and 50 degree medium helix allows an extremely wide range of application.
• YG:TYLON super TiAlN coating are recommended for maximum performance.