Direct From Factory YG1 34600 1″ Size, 1-1/2″ LOC, 3 Flute, Bright Solid Carbide Finishing End Mill

Applications

This YG1 1-inch solid carbide finishing end mill features three flutes and a 45° high helix angle that promotes efficient chip evacuation and a smooth surface finish. The bright finish coating suits aluminum, brass, bronze, copper, plastics, and general low-to-moderate speed machining where a sharp, polished cutting edge is preferred. Its center-cutting design enables plunge cuts and ramping operations, expanding its versatility. The single-end tool offers a length of cut of 1-1/2″ and a 4-inch overall length, balancing reach and rigidity for finishing passes. Operators should select this end mill when machining non-ferrous and softer materials requiring fine surface quality and precise detail. The high helix geometry combined with the bright finish delivers clean shearing action while maintaining tool strength throughout the cut.

Features

• Designed to machine stainless steel, inconel, titanium and other hard to machine materials.
• It’s 3 flute design gives high stability and allows good chip removal in plunging & slotting operations.
• The normal rake angle and 45 degree medium helix allows an extremely wide range of application.
• YG:TYLON super TiAlN coating are recommended for maximum performance.