Instant Buy YG1 07598TC 3/4″ Size, 1-1/2″ LOC, 4 Flute, TiCN Solid Carbide Finishing End Mill

Little to no coolant required with TiAlN Futura Coating!

Applications

Sized at 3/4″ diameter with a 1-1/2″ length of cut, the YG1 07598TC solid carbide finishing end mill features a balanced stub length that promotes rigidity and precision during milling operations. Its 4-flute arrangement and 30° helix angle facilitate smooth chip evacuation and stable cutting forces, supporting consistent surface finishes in free-machining steel and cast iron.
The TiCN coating enhances wear resistance and reduces built-up edge formation, extending tool life through finishing passes. Center-cutting geometry enables plunge cutting, increasing versatility in complex milling tasks. The tools lack of a corner radius prioritizes sharp edge finishes but requires careful feed control to avoid chipping.
This end mill should not be used on heat-resistant superalloys (HRSA) due to coating unsuitability which can cause premature wear. It aligns closely with recommended uses for general milling of free-machining steel and is also suitable for light profiling of non-ferrous metals like brass and bronze.

Features

• Possible for high-speed cutting, suitable for high efficiency machining for hardened & high alloy steels, steel casting, chill casting, malleable cast iron, CrNi-steels, brass, copper, aluminum with a high percentage of silicon and abrasive plastics.